Skip to content

How to use METER puzzle

Process:

  1. First put the WHEN puzzle, and after that you can add other puzzles
  2. Add 2 IF puzzle blocks into WHEN puzzle
  3. Add SENSOR in WHEN puzzle
  4. Open OPERATOR section and choose 2 puzzles, one which is greater than or equal to, and the other one that is less than or equal to
  5. Now go to SENSOR and add METER into OPERATOR block
  6. After we are done with adding METER to OPERATOR, we will add action which will trigger our cooling system
  7. Now it's time to go to DEVICES and add Sensors and Meters
  8. We will add Zipato 3 in 1 sensor which will be triggered by temperature
  9. In this case we will add Zipato 3 in 1 sensor and select Temperature
  10. Go to METER and we will select the same device, and put it into METER puzzle
  11. We have to select which value we will trigger, so in this case we will select temperature and set 28°C
  12. After we define at which point our rule will trigger, it's time to add Thermostat which will start cooling until it get's to the 23°C
  13. The same is with 2nd IF puzzle, but only thing that is different will be the value of the temperature which will be set to 23°C, and the cooling will go OFF
  14. After you are done, SAVE and SYNC rule
Video guideHow to use METER puzzleLoads from YouTube when played